konig rewind 16 x 7 4 x 114.3mm 0 offset graphite wheels

Also, you must install the Konig center caps onto the wheels BEFORE installing the wheels onto the front of your Z. To run these Konig center caps in the front of your early Z-Car, the small, metal factory bearing caps must be flattened slightly (less than 1/4 of an inch) to allow room for the Konig center cap. Note that as with all Konig Rewind wheels that we offer, the center caps are slightly too short for the front bearing caps. On the other hand, machining the lip will still result in a reflective but not mirror-like finish, and can leave very fine lines in the surface (which are only visible on very close inspection).

The key difference is that polishing typically results in a mirror-like finish when done correctly, but is a much more tedious process (which results in a higher cost). Both have a very bright, reflective finish and look amazing. The lip area of these wheels is machined, which creates a similar appearance to polishing. Our complete kit includes 4 wheels, 16 Chrome lug nuts, 4 Chrome-sleeved valve stems (with chrome caps), and 4 Chrome center caps. The wheels are direct bolt-on, requiring no adapters, for 70-85 240Z, 260Z, 280Z, 280ZX, and 300ZX (4-Lug configuration only). These popular 16x7' Konig Rewind wheel kits look awesome in Graphite with a machined lip*. (4) Chrome Sleeved Valve Stem w/ Chrome Cap.(4) 16x7' Gloss Graphite Konig Rewind Wheel w/ Machined Lip.For Alaska, Hawaii, Military, US Territory, and international shipments, we'll discount your shipping rate accordingly! Simply complete your order (select the TBD shipping option at checkout), we'll find the best rate, and get back to you with the details (you will not be charged until you approve the amount). FREE SHIPPING to the contiguous (lower 48) United States (standard ground service).

Konig rewind 16 x 7 4 x 114.3mm 0 offset graphite wheels